About a month ago I ran diagnostics on the Rostra cc install. It passed that just fine. I'm using the switch with an Engage light, so have a second relay in the circuit.
Today I took her out and got on US 81 North from Hagerstown to Chambersburg, which includes a long fairly steep incline which in the winter has tractor-trailers jacknifed and sliding down the hill.
The Rostra lit up the on light, and the illumination lights on the arrow buttons were on. I got up to speed, put her in Ecco mode, and thumbed SET. Darned if it didn't set instantly. So far so good.
Next, I pressed Accel arrow, and she sped up and when I quit pressing she set to the new speed. So I tried the Decel button, and she slowed down and set to the new speed when I released the button.
Then I touched the brakes, and she disengaged, and then I pressed Resume and she picked right up to the old speed.
I'm stoked, it was a lot of work and I cut all the wires down to just the length required, so there was always a chance I miss-spliced something or didn't solder properly.
So.... WOOHOO .... this is going to make going to Arkansas much nicer!
Living the Gypsy Life